Is there anyone who knows the rigctl command to switch my IC-7100 into data mode, as well as changing the filters ?
M USB 2 may do the trick for the filter selection, but unfortunately it does not work.
Alternatively, would anyone know the correct syntax for a raw command, as in :
send_raw icom xfe:xfe:x88:xe1:x03:xfd
The reply to this is a dump of multiple lines which are not really relevant.
If data mode and filter selection is not implemented, a raw command is good as well.
Tried this on wfview 2.03 and 2.04 - latest.
And my sincere congrats to the development group for the latest releases !
73’s Erik
ON4PB